Nice hacks for satellites with hu support and emulators, we got CMD90 too.

When you want to go into read/writer mode, simply insert a smart card into the unit and then push the rear mounted micro push button for approx. After an smartcard programmer has finished processing a packet, it must send a two-byte status word to the host device, informing the host device of the outcome of the transaction. Just like a chip, a wafer card has a flat silicon "wafer" built-in, with tiny wires connected to the gold plated terminals on the smartcard. Stealth: Exactly the same as 3m except for one important detail: the script closes all known write-functionality of the card. ISO Programmer- a piece of equipment to read the cards ATR and a couple of other pieces of information but as a newbie the most critical one is the ATR.

PAL TV consists of 24 frames per second, and sometimes MPEG doesn't describe the full frame, but instead only describes what has changed between two similar frames! The crew over at Acidlab is after pure power and cute don't cut it with these guys. It does exactly what it claims it will do which is allow otherwise screwed cards to run again after you aux the card and run it in this avr lookalike. Stealth A term for a script that completely locks all writes to the card and disguises some parts of it. Tune to Channel 100 Remove Access card Press and hold the Down Arrow and Power on/off buttons simultaneously Still holding the buttons down, pull the power cord from the electrical outlet Still holding the buttons down, wait 60 seconds Plug the power cord back into the electrical outlet Still holding buttons down, wait 15 seconds more Insert your access card and release the keys all while on channel 100 If screen says "Searching for Satellite", procedure was successful. If your having trouble, might want to try that. I had to use a telephone cable for the Emu, after hooking everything up, I booted up the computer and pulled card after the second beep then BAM, a running Emu system. This is more of a hobby where we learn about smart cards, how they work, and how to program them in ways that just happens to open up all the channels for viewing. E3 HOLE = This can be considered as the 'main enterance' to your card. The specification for smartcard ICs, as set down by the International Standards Organization.

Missed Sports, Sex, Porno, Playboy. Right place for DRD502RB Receivers, emulation, soft reboot receiver and valid Scripts.

The Detonator UL comes with winexplorer 4.8 software with dealer scripts meant to lock down your bins from Prying eyes. which always gets special praise from me. This unit will fix about 95% (give or take a point or two) of the Hu cards out there. Take note of the resin cast adapter guide which appears to fit the standard Dish JTAG port like a glove (very important while uploading new firmware!) Additional pics and assembly diagrams and blueprints will be posted over next day or so at this link. If the ZKT shows the CAM ID to be fake, it gives a "Insert Valid Access Card" message on the screen, and doesn't read the card any further.

Married card archive, support for private script, DRD303RA Receivers, TSOP locks.